Hitachi F-ZTAT H8/3039 Series Hardware Manual page 452

Bit 6:
SWE Description
0 Program/erase disabled
1 Program/erase enabled
[Setting condition]
When FWE = 1
Bit 5—Erase Setup Bit (ESU) *
PSU, EV, PV, E, or P bit at the same time.
Bit 5:
ESU Description
0 Erase setup cleared
1 Erase setup
[Setting condition]
When FWE = 1, and SWE = 1
Bit 4—Program Setup Bit (PSU) *
SWE, ESU, EV, PV, E, or P bit at the same time.
Bit 4:
PSU Description
0 Program setup cleared
1 Program setup
[Setting condition]
When FWE = 1, and SWE = 1
Bit 3—Erase-Verify (EV) *
SWE, ESU, PSU, PV, E, or P bit at the same time.
Bit 3:
EV Description
0 Erase-verify mode cleared
1 Transition to erase-verify mode
[Setting condition]
When FWE = 1, and SWE = 1
Bit 2—Program-Verify (PV)*
the SWE, ESU, PSU, EV, E, or P bit at the same time.
1
: Prepares for a transition to erase mode. Do not set the SWE,
1
: Prepares for a transition to program mode. Do not set the
1
: Selects erase-verify mode transition or clearing. Do not set the
1
: Selects program-verify mode transition or clearing. Do not set
(Initial value)
(Initial value)
(Initial value)
(Initial value)
443