Rebuilding The Default Settings - Fujitsu PRIMERGY BX600 User Manual

The Management Blade

Rebuilding the default settings

There are two ways to rebuild the default settings:
– The preferred way
Rebuilding with HyperTerminal
In this case you can control the procedure.
– The second way, only if you have no chance to connect the management blade
Rebuilding without HyperTerminal
In this case you have no control over the procedure.
Requirements
– Power cords are connected.
Rebuilding with HyperTerminal
The procedure described below is to be performed for each of both
!
management blades.
Ê Connect the serial cable from the management blade to an external PC.
Ê Activate HyperTerminal (see
Ê Remove the management blade (see
02 BX600 120
– –
Removal and Installation Routines
page 02-BX600-56).
page 02-BX600-115).
March 2006
U41057-J21-Z146-1-76