Mounting The Assembly Kit - Fujitsu PRIMERGY BX600 User Manual

Installing the System in the Rack

Mounting the Assembly Kit

Mounting the server in the PRIMECENTER/DataCenter rack requires the
following parts:
– 2 support brackets
– 2 carrier rails (assembled)
– 12 plug washers and screws
i
For general information see the technical manual for the relevant rack.
To mount the system in the rack, you must first mount two support brackets on
the rear left support upright of the rack. The first one must be mounted level with
the lower edge of the device, while the second must be mounted level with the
upper edge of the first. The brackets are used for the rear fixing of the left carrier
rail.
Ê See the installation instructions in the technical manual for the relevant rack
model.
Ê Mark the position of the lower edge of the system on the support uprights.
Ê Place the first support bracket at the appropriate height (level with the lower
edge of the device) on the left rear support upright by inserting the
positioning nubs (1 in the figure above) in the corresponding holes of the
support upright.
Ê Place the plug washers in the holes of the support uprights and secure the
bracket with two screws.
02 BX600 148
– –
1
March 2006
Removal and Installation Routines
U41057-J21-Z146-1-76