Installation and initial operation
Possible screen resolutions
Depending on the operating system used, the screen resolutions in the following
table refer to the screen controller on the system board. If you are using an
external screen controller, you will find details of supported screen resolutions
in the Operating Manual or Technical Manual supplied with the controller.
Screen resolutions
640x480
800x600
1024x768
1057x864
1280x1024
1600x1200
Management Blade Initial Configuration
The management blade provides functions for managing the blade server
system remotely via the LAN. For initial operation of the blade server system the
LAN parameters of the management blade must be configured.
A local client system is required to perform the initial configuration of the
management blade.
To configure the management blade, follow the steps listed below.
Pre-configuration requirements
The procedures that follow assume that the blade server is connected to the
power line.
Cabling the system
Ê Connect the serial port of the client (COM1) to the serial port of the master
management blade.
i
The master management blade is indicated by a green LED (see
page
02-BX600-51).
U41057-J21-Z146-1-76
Refresh rates (Hz)
200
200
200
120
100
75
March 2006
Maximum number of colors
16.7 million
16.7 million
16.7 million
16.7 million
16.7 million
16.7 million
02
–
Settings
BX600
55
–