ABB ACS355 User Manual page 179

Actual signals
No. Name/Value
0129 PID 2 SETPNT Setpoint signal (reference) for the PID2 controller. Unit
0130 PID 1 FBK
0131 PID 2 FBK
0132 PID 1
DEVIATION
0133 PID 2
DEVIATION
0134 COMM RO
WORD
0135 COMM VALUE
1
0136 COMM VALUE
2
0137 PROCESS
VAR 1
0138 PROCESS
VAR 2
0139 PROCESS
VAR 3
0140 RUN TIME
0141 MWH
COUNTER
0142 REVOLUTION
CNTR
0143 DRIVE ON
TIME HI
0144 DRIVE ON
TIME LO
0145 MOTOR TEMP Measured motor temperature. Unit depends on the sensor
0146 MECH ANGLE Calculated mechanical angle
Description
depends on parameter
settings.
Feedback signal for the process PID1 controller. Unit
depends on parameter
and 4027 PID 1 PARAM SET
Feedback signal for the PID2 controller. Unit depends on
parameter 4106 UNITS
Deviation of the process PID1 controller, ie the difference
between the reference value and the actual value. Unit
depends on parameter
and 4027 PID 1 PARAM SET
Deviation of the PID2 controller, ie the difference between
the reference value and the actual value. Unit depends on
parameter 4106 UNITS
Relay output Control word through fieldbus (decimal). See
parameter 1401 RELAY OUTPUT
Data received from fieldbus
Data received from fieldbus
Process variable 1 defined by parameter group
DISPLAY
Process variable 2 defined by parameter group
DISPLAY
Process variable 3 defined by parameter group
DISPLAY
Elapsed drive running time counter (thousands of hours).
Runs when the drive is modulating. Counter cannot be
reset.
MWH counter. The counter value is accumulated till it
reaches 65535 after which the counter rolls over and starts
again from 0. Cannot be reset.
Motor revolution counter (millions of revolutions). The
counter can be reset by pressing UP and DOWN keys
simultaneously when the control panel is in the Parameter
mode.
Drive control board power-on time in days. Counter cannot
be reset.
Drive control board power-on time in 2 second ticks (30
ticks = 60 seconds). Counter cannot be reset.
type selected by group
parameters.
Actual signals and parameters 179
4106 UNITS and 4107 UNIT SCALE
4006 UNITS, 4007 UNIT SCALE
settings.
and 4107 UNIT SCALE
4006 UNITS, 4007 UNIT SCALE
settings.
and 4107 UNIT SCALE
1.
35 MOTOR TEMP MEAS
FbEq
-
-
-
settings.
-
-
settings.
1 = 1
1 = 1
1 = 1
34 PANEL -
34 PANEL -
34 PANEL -
1 = 0.01
kh
1 = 1
MWh
1 = 1
Mrev
1 = 1
days
1 = 2 s
1 = 1
1 = 1