ABB ACS355 User Manual page 235

All parameters
No. Name/Value
ON (LOAD)
2608 SLIP COMP
RATIO
0...200%
2609 NOISE
SMOOTHING
DISABLE
ENABLE
Description
The drive is started with 4 kHz switching frequency to gain
maximum output during the start. After start-up, the
switching frequency is controlled towards the selected value
(parameter 2607 SWITCH FREQ
current or the temperature allows.
This selection provides adaptive switching frequency
control. Adaptation decreases the output performance in
some cases.
f
limit
sw
16 kHz
4 kHz
80...100 °C *
50% **
* Temperature depends on the drive output frequency.
** Short term overloading is allowed with each switching
frequency depending on actual loading.
Defines the slip gain for the motor slip compensation
control. 100% means full slip compensation, 0% means no
slip compensation. Other values can be used if a static
speed error is detected despite the full slip compensation.
Can be used only in scalar control (ie when parameter
MOTOR CTRL MODE
Example: 35 Hz constant speed reference is given to the
drive. Despite the full slip compensation
RATIO = 100%), a manual tachometer measurement from
the motor axis gives a speed value of 34 Hz. The static
speed error is 35 Hz - 34 Hz = 1 Hz. To compensate the
error, the slip gain should be increased.
Slip gain
Enables the noise smoothing function. Noise smoothing
distributes the acoustic motor noise over a range of
frequencies instead of a single tonal frequency resulting in
lower peak noise intensity. A random component with an
average of 0 Hz is added to the switching frequency set by
parameter 2606 SWITCHING
Note: Parameter has no effect if parameter
SWITCHING FREQ is set to 16 kHz.
Disabled
Enabled
Actual signals and parameters 235
CTRL) if the output
Drive current I
Drive
temperature
100...120 °C *
100% **
setting is SCALAR: FREQ).
(SLIP COMP
FREQ.
Def/FbEq
2
2N
T
0%
9904
1 = 1%
DISABLE
2606
0
1