ABB ACS355 User Manual page 345

CODE FAULT
0009 MOT OVERTEMP
(4310)
0305 bit 8
(programmable fault
function
3005...3009
0010 PANEL LOSS
(5300)
0305 bit 9
(programmable fault
function 3002)
0011 ID RUN FAIL
(FF84)
0305 bit 10
0012 MOTOR STALL
(7121)
0305 bit 11
(programmable fault
function
3010...3012)
0014 EXT FAULT 1
(9000)
0305 bit 13
(programmable fault
function 3003)
CAUSE
Motor temperature is
too high (or appears to
be too high) due to
excessive load,
insufficient motor
power, inadequate
cooling or incorrect
/ 3504)
start-up data.
Measured motor
temperature has
exceeded fault limit set
by parameter
FAULT LIMIT.
Control panel selected
as active control
location for drive has
ceased
communicating.
Motor ID run is not
completed
successfully.
Motor is operating in
stall region due to eg
excessive load or
insufficient motor
power.
External fault 1
WHAT TO DO
Check motor ratings, load and cooling.
Check start-up data.
Check fault function parameters.
Check value of fault limit.
Check that actual number of sensors
corresponds to value set by parameter
3504
3501 SENSOR
Let motor cool down. Ensure proper
motor cooling: Check cooling fan,
clean cooling surfaces, etc.
Check panel connection.
Check fault function parameters.
Check control panel connector.
Refit control panel in mounting
platform.
If drive is in external control mode
(REM) and is set to accept start/stop,
direction commands or references
through control panel:
Check group
and 11 REFERENCE SELECT
settings.
Check motor connection.
Check start-up data (group
UP DATA).
Check maximum speed (parameter
2002). It should be at least 80% of
motor nominal speed (parameter
9908).
Ensure ID run has been performed
according to instructions in section
How to perform the ID run
Check motor load and drive ratings.
Check fault function parameters.
Check external devices for faults.
Check parameter
FAULT 1 setting.
Fault tracing 345
TYPE.
10 START/STOP/DIR
99 START-
on page 69.
3003 EXTERNAL