Relay Outputs - ABB ACS355 User Manual

Hide thumbs Also See for ACS355:
Table of Contents

Advertisement

All parameters
No.
Name/Value
14 RELAY OUTPUTS Status information indicated through relay output, and relay
1401 RELAY
OUTPUT 1
NOT SEL
READY
RUN
FAULT(-1)
FAULT
ALARM
REVERSED
STARTED
SUPRV1
OVER
SUPRV1
UNDER
SUPRV2
OVER
SUPRV2
UNDER
SUPRV3
OVER
SUPRV3
UNDER
AT SET POINT Output frequency is equal to the reference frequency.
FAULT(RST)
FLT/ALARM
EXT CTRL
REF 2 SEL
CONST FREQ A constant speed is in use. See parameter group
REF LOSS
OVERCURRE
NT
Description
operating delays.
Note: Relay outputs 2...4 are available only if the MREL-01
relay output extension module is connected to the drive.
See MREL-01 relay output extension module user's manual
(3AUA0000035974 [English]).
Selects a drive status indicated through relay output RO 1.
The relay energizes when the status meets the setting.
Not used
Ready to function: Run enable signal on, no fault, supply
voltage within acceptable range and emergency stop signal
off.
Running: Start signal on, Run enable signal on, no active
fault.
Inverted fault. Relay is de-energized on a fault trip.
Fault
Alarm
Motor rotates in reverse direction.
The drive has received start command. Relay is energized
even if Run enable signal is off. Relay is de-energized when
drive receives a stop command or a fault occurs.
Status according to supervision parameters 3201...3203.
See parameter group
See selection
SUPRV1
Status according to supervision parameters 3204...3206.
See parameter group
See selection
SUPRV2
Status according to supervision parameters 3207...3209.
See parameter group
See selection
SUPRV3
Fault. Automatic reset after the autoreset delay. See
parameter group
31 AUTOMATIC
Fault or alarm
Drive is under external control.
External reference REF 2 is in use.
CONSTANT
SPEEDS.
Reference or active control location is lost.
Alarm/Fault by overcurrent protection function
Actual signals and parameters 199
32
SUPERVISION.
OVER.
32
SUPERVISION.
OVER.
32
SUPERVISION.
OVER.
RESET.
Def/FbEq
FAULT(-1)
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
12
19
20
21

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents