ABB ACS355 User Manual page 342

342 Fault tracing
ALARM CODE CAUSE
5029 Memory is not ready.
5030 Invalid request
5031 Drive is not ready for
operation, eg due to low
DC voltage.
5032 Parameter error
5040 Parameter download error.
Selected parameter set is
not in current parameter
backup file.
5041 Parameter backup file
does not fit into memory.
5042 Parameter download error.
Selected parameter set is
not in current parameter
backup file.
5043 No start inhibit
5044 Parameter backup file
restoring error
5050 Parameter upload aborted
5051 File error
5052 Parameter upload has
failed.
5060 Parameter download
aborted
5062 Parameter download has
failed.
5070 Panel backup memory
write error
5071 Panel backup memory
read error
5080 Operation is not allowed
because drive is not in
local control mode.
5081 Operation is not allowed
because of active fault.
5083 Operation is not allowed
because parameter lock is
on.
5084 Operation is not allowed
because drive is
performing a task.
5085 Parameter download from
source to destination drive
has failed.
5086 Parameter download from
source to destination drive
has failed.
WHAT TO DO
Retry.
Contact your local ABB representative.
Check input power supply.
Contact your local ABB representative.
Perform upload function before download.
Contact your local ABB representative.
Perform upload function before download.
Check that file is compatible with drive.
Retry parameter upload.
Contact your local ABB representative.
Retry parameter upload.
Retry parameter download.
Retry parameter download.
Contact your local ABB representative.
Contact your local ABB representative.
Switch to local control mode.
Check cause of fault and reset fault.
Check parameter 1602 PARAMETER LOCK
setting.
Wait until task is completed and retry.
Check that source and destination drive types
are same, ie ACS355. See type designation
label of the drive.
Check that source and destination drive type
designations are the same. See type
designation labels of the drives.