Torque Control Macro; Default I/O Connections - ABB ACS355 User Manual

118 Application macros

Torque control macro

This macro provides parameter settings for applications that require torque control of
the motor. Control can also be switched to speed control using a digital input. To
enable the macro, set the value of parameter
CTRL).
For the parameter default values, see section
page 176. If you use other than the default connections presented below, see section
I/O terminals on page 51.

Default I/O connections

1...10 kohm
max. 500 ohm
1)
Speed control: Changes rotation direction.
Torque control: Changes torque direction.
2)
0 = ramp times according to parameters
2202 and 2203.
1 = ramp times according to parameters
2205 and 2206.
3)
360 degree grounding under a clamp.
X1A
1 SCR Signal cable shield (screen)
2 AI1 Motor speed reference (Speed): 0...10 V
3 GND Analog input circuit common
4 +10V Reference voltage: +10 V DC, max. 10 mA
5 AI2 Motor torque reference (Torque): 4...20 mA
6 GND Analog input circuit common
7 AO Motor speed value: 0...20 mA
8 GND Analog output circuit common
3)
9 +24V Auxiliary voltage output: +24 V DC, max. 200 mA
10 GND Auxiliary voltage output common
11 DCOM Digital input common
12 DI1 Stop (0) / Start (1) (Speed)
13 DI2 Forward (0) / Reverse (1)
14 DI3 Speed (0) / Torque (1) control selection
15 DI4 Constant speed 1: parameter
16 DI5 Acceleration and deceleration selection
X1B
17 ROCOM
18 RONC
19 RONO
20 DOSRC
21 DOOUT
22 DOGND
9902 APPLIC MACRO
Default values with different macros
Relay output 1
No fault [Fault (-1)]
Digital output, max. 100 mA
No fault [Fault (-1)]
4)
The signal source is powered externally. See
the manufacturer's instructions. To use
sensors supplied by the drive aux. voltage
output, see page 53.
Tightening torque = 0.4 N·m / 3.5 lbf·in.
Safe torque off connections (X1C:STO; not
shown in the diagram) are jumpered by default.
to 8 (TORQUE
4)
1)
1202
2)
on