ABB ACS355 User Manual page 222

222 Actual signals and parameters
All parameters
No. Name/Value
2108 START INHIBIT Sets the Start inhibit function on or off. If the drive is not
OFF
ON
2109 EMERG STOP
SEL
NOT SEL
DI1
DI2
DI3
DI4
DI5
DI1(INV)
DI2(INV)
DI3(INV)
DI4(INV)
DI5(INV)
2110 TORQ BOOST
CURR
15...300%
2111 STOP SIGNAL
DLY
0...10000 ms
Description
actively started and running, the Start inhibit function
ignores a pending start command in any of the following
situations and a new start command is required:
• a fault is reset.
• Run enable signal activates while the start command is
active. See parameter
• control mode changes from local to remote.
• external control mode switches from EXT1 to EXT2 or
from EXT2 to EXT1.
Disabled
Enabled
Selects the source for the external emergency stop
command.
The drive cannot be restarted before the emergency stop
command is reset.
Note: The installation must include emergency stop devices
and any other safety equipment that may be needed.
Pressing the stop key on the drive's control panel does
NOT:
• generate an emergency stop of the motor
• separate the drive from dangerous potential.
Emergency stop function is not selected
Digital input DI1. 1 = stop along the emergency stop ramp.
See parameter 2208 EMERG DEC
stop command reset.
See selection DI1.
See selection DI1.
See selection DI1.
See selection DI1.
Inverted digital input DI. 0 = stop along the emergency stop
ramp. See parameter
emergency stop command reset
See selection DI1(INV).
See selection DI1(INV).
See selection DI1(INV).
See selection DI1(INV).
Defines the maximum supplied current during torque boost.
See parameter 2101 START
Value in percent
Defines the stop signal delay time when parameter
STOP FUNCTION is set to
Delay time
1601 RUN ENABLE.
TIME. 0 = emergency
2208 EMERG DEC TIME. 1 =
FUNCTION.
SPEED COMP.
Def/FbEq
OFF
0
1
NOT SEL
0
1
2
3
4
5
-1
-2
-3
-4
-5
100%
1 = 1%
2102 0 ms
1 = 1 ms