ABB ACS355 User Manual page 180

180 Actual signals and parameters
Actual signals
No. Name/Value
0147 MECH REVS
0148 Z PLS
DETECTED
0150 CB TEMP
0158 PID COMM
VALUE 1
0159 PID COMM
VALUE 2
0160 DI 1-5 STATUS Status of digital inputs.
0161 PULSE INPUT
FREQ
0162 RO STATUS
0163 TO STATUS
0164 TO
FREQUENCY
0165 TIMER VALUE Timer value of timed start/stop. See parameter group
0166 COUNTER
VALUE
0167 SEQ PROG
STS
0168 SEQ PROG
STATE
0169 SEQ PROG
TIMER
0170 SEQ PROG AO
VAL
0171 SEQ CYCLE
CNTR
0172 ABS TORQUE Calculated absolute value of the motor torque in percent of
Description
Mechanical revolutions, ie the motor shaft revolutions
calculated by the encoder
Encoder zero pulse detector. 0 = not detected, 1 = detected. 1 = 1
Temperature of the drive control board in degrees Celsius
(0.0...150.0 °C).
Data received from fieldbus for PID control (PID1 and PID2) 1 = 1
Data received from fieldbus for PID control (PID1 and PID2) 1 = 1
Example: 10000 = DI1 is on, DI2...DI5 are off.
Value of frequency input in Hz
Status of relay output 1. 1 = RO is energized, 0 = RO is de-
energized.
Status of transistor output, when transistor output is used as
a digital output.
Transistor output frequency, when transistor output is used
as a frequency output.
TIMER & COUNTER.
Pulse counter value of counter start/stop. See parameter
group 19 TIMER & COUNTER.
Status word of the Sequence programming:
Bit 0 = ENABLED (1 = enabled)
Bit 1 = STARTED
Bit 2 = PAUSED
Bit 3 = LOGIC VALUE (logic operation defined by
parameters 8406...8410).
Active state of the Sequence programming. 1...8 = state
1...8.
Current state time counter of the Sequence programming
Analog output control values defined by the Sequence
programming. See parameter
Executed sequence counter of the Sequence programming.
See parameters 8415 CYCLE CNT LOC
CNT RST.
the motor nominal torque
8423 ST1 OUT CONTROL.
and 8416 CYCLE
FbEq
1 = 1
1 = 0.1 °C
1 = 1 Hz
1 = 1
1 = 1
1 = 1 Hz
19 1 = 0.01 s
1 = 1
1 = 1
1 = 1
1 = 2 s
1 = 0.1%
1 = 1
1 = 0.1%