Figure 3-53 Wall Mount Positioning For 9.5" Base/Expansion Chassis - NEC Univerge SV9100 System Hardware Manual

Hide thumbs Also See for Univerge SV9100:

Table of Contents

Wall Mounting the 9.5" Gateway (CHS2UG GW-US) and Base

(CHS2UG B-US) Chassis

When wall mounting the chassis, ensure the wall can support the weight of the

chassis and (25 lbs per system chassis ---- including blades, cords, power supply,

etc.). The chassis is secured to the wall with a wall mount bracket.

Optional wall mounting procedures exist for the 9.5" chassis. Option 1: the

mounting bracket is secured to the wall and the chassis is attached to the bracket.

Option 2 attaches the bracket to the 9.5" chassis and then, using the key-holes as

a guide, the assembled unit slides over screws secured to the wall using the

template shown in

To wall mount the Base and Expansion chassis as a combined unit, refer to

4.2.1.1 Wall Mounting the 9.5" Base (CHS2UG B-US) and Expansion

(CHS2UG E) Chassis on page

To wall mount the CHS2UG B-US with the external battery installed, refer to

4.2.2.2 Wall Mounting the CHS2UG B-US with the CHS2UG B Small Batt

Option 1 – Wall Mounting the 9.5 inch Base

When mounted, clearance between the wall and the CHS2UG B-US/

CHS2UG E chassis is approximately 1.7 in (43mm) due to height of

the wall mounting bracket.

The chassis must be mounted horizontally with the slot (front) side on

Figure 3-53 Wall Mount Positioning for 9.5" Base/Expansion Chassis

Due to EXIFU cable length, a maximum of 2 (1 CHS2UG B-US and 1

CHS2UG E) chassis can be wall mounted. If additional chassis are to be

mounted, consider using the floor mounting procedure.

Installing the SV9100 Chassis

Table of Contents