Table 4-31 Gcd-4Diopa Rj-61 Cable Connector Pin-Outs - NEC Univerge SV9100 System Hardware Manual

Table 4-30 GCD-4DIOPA LED Indications (Continued)
LED Indication
Live LED
Busy LED (Red)
(Green)
On
Off
Off
Flash 80ms (On/
Off) x 3/400ms
Off
4-74
Operation Status
A Channel is busy (use
Unit Busy
another from CH1 ~ CHx).
All channels are idle.
Downloading firmware.
5.5.4 Connectors
The CN2 connector provides connection to four analog DID trunk ports,
which are polarity sensitive (tip-to-tip, ring-to-ring). The OPX circuits,
however, are not polarity sensitive. The GCD-4DIOPA requires one
universal slot. (Refer to
Program 10-03-01 has OPX defined, note that the blade consumes four
(4DIOPA) trunks and extension ports when installed. If OPX is not defined,
then only trunks ports are consumed.

Table 4-31 GCD-4DIOPA RJ-61 Cable Connector Pin-Outs

pin-outs for the RJ-61 connector.
4-72 shows the location of the connectors on the 4DIOPA blade.
Table 4-31 GCD-4DIOPA RJ-61 Cable Connector Pin-Outs
–
–
–
Figure 4-25 GCD-4DIOPA Blade on page
Figure 4-25 GCD-4DIOPA Blade on page
RJ-61 Cable Connector – CN2
Line No. Pin No.
1 5
4
2 3
6
3 2
7
4 1
8
Issue 3.0
Remarks
4-72.) If
shows the
Connection
Tip
Ring
Tip
Ring
Tip
Ring
Tip
Ring
Installing the SV9100 Blades