Figure 5-99 Securing The Dcl-60-1/Dcz-60-2 Console With Screws; Figure 5-100 Serial Cable Installed - NEC Univerge SV9100 System Hardware Manual

Issue 3.0
SV9100 System Hardware Manual
9. Secure the DCL-60-1/DCZ-60-2 CONSOLE to the bracket
with the two screws provided.
Figure 5-99 Securing the DCL-60-1/DCZ-60-2 CONSOLE with
Screws
10. Open the small door covering the side option connectors by
pulling the cover latch toward you (refer to
Serial Cable Installed, ITL, DT700 only).
11. Connect the cable from the DCL-60-1/DCZ-60-2 CONSOLE
to the Side Option Connector on the multiline terminal and
close the cover (DT700/DT800 only).

Figure 5-100 Serial Cable Installed

12. Set the tilt leg on the multiline terminal to the desired height.
Figure 5-100
5-91