Table 4-9 Gcd-Cp10 Connections; Table 4-10 Gcd-Cp10 Rj45 Cable Connector Pin-Outs - NEC Univerge SV9100 System Hardware Manual

RUN (D23)
Blinking
Blinking
Blinking
Blinking
Blinking
Blinking
4-24
Table 4-8 GCD-CP10 LED Indications (Continued)
LED Indication
D20 D21
Off On
Off On
On On
Blinking Blinking Blinking On Steady When
On Off
Blinking Off
On Off Off
3.1.5 Connectors

Table 4-9 GCD-CP10 Connections

GCD-CP10

Table 4-10 GCD-CP10 RJ45 Cable Connector Pin-Outs

,
describes the pin-outs for connectors on the GCD-CP10. Refer to
4-6 GCD-CP10 Blade Layout on page 4-15
connections on the GCD-CP10 blade.
Table 4-9 GCD-CP10 Connections
Connector
J13
J4
J11/J12
J10
J6/S4
D22 D25
Off On Steady When
USB Memory is
Installing
On On Steady When
USB Memory is
Installing
On On Steady When
USB Memory is
Installing
USB Memory is
Installing
Off On Steady When
USB Memory is
Installing
Off On Steady When
USB Memory is
Installing
Off Off
describes each connector on the
Connector Description
USB Memory Connection (used for upgrading software or
downloading system data)
Ethernet Cable Connection (for PCPro or WebPro, CTI,
ACD MIS, IP Phone)
Pin Jack for External Source Connection (External MOH,
External Speaker, etc.)
External Source Control Connection
Used for Debug
Issue 3.0
Status
SRAM error
SD memory booting error
SD memory data error
Reading error of system
program
Error: Major alarm occurred
Error: Minor alarm occurred
System starting up
Figure
for the location of the
Installing the SV9100 Blades