Table 4-4 Default Port Settings - NEC Univerge SV9100 System Hardware Manual

Issue 3.0
SV9100 System Hardware Manual
2.6.3.2 Port Defaults
With the default settings, the ports are assigned as follows:

Table 4-4 Default Port Settings

Port 1~99 : 101~199
Station Ports:
Port 100~199 : 3101~3200
Port 200~960 : 3201~3961
Port 1~99 : 201~299
Virtual Station
Port 100~512 : No Setting
Ports:
1~400
Trunk Ports:
In the initial configuration:
All Programmable Function keys are line keys (e.g., key 1 is

line 1).
All trunks are loop start DTMF.

2.6.3.3 Setting Up Extension Circuit Types
Run Program 10-03 to set up extension circuit types as
required. The system automatically detects and assigns most
circuit types when the device is connected.
1. Dial 10-03-01.
2. Press TRANSFER to Select the slot, port or channel (with
ESIU Blades) to be programmed.
3. Set the terminal type or option as needed.
If the system has DSS Consoles, Program 30-02 must be

used to define DSS extension assignments.
As the system recognizes the extension devices automatically,
when replacing the connected device, it must be undefined in
Program 10-03 prior to connecting the new device. For
example, if a port was previously used for a telephone and a
DSS Console is to be installed in that same port, the telephone
must first be undefined in Program 10-03 before the console is
connected.
2.6.3.4 Saving Your Configuration
When programming is completed, to exit out of the program
option and save changes to the GCD-CP10:
1. Press EXIT to exit the program options, if needed.
2. Press Speaker.
Saving System Data is displayed if changes were made to
system programming.
3. The display shows Complete Data Save when completed
and the telephone becomes idle.
4-11