Figure 9-16 Cpru Connections - NEC Univerge SV9100 System Hardware Manual

Hide thumbs Also See for Univerge SV9100:

Table of Contents

If a line cord was not previously connected to the PGD(2)-U10 ADP,

complete Steps 3~6. Otherwise, skip to Step 7.

Install a modular jack for each PGD(2)-U10 ADP. For each module, run

one-pair 24 AWG station cable from the cross-connect block to a modular

jack. Ground the unused pair.

Terminate the extension leads to GRN/RED of the modular jack. Terminate

the unused leads to the jack.

Install bridging clips as required.

Plug a modular line cord from the mod jack to the CN1 connector on the

PGD(2)-U10 ADP.

Connect an RCA jack to the audio output(s) on the back of the

PGD(2)-U10 ADP.

The opposite end of this cable is connected to the external music source

either directly or by connecting to the cross-connect block where the music

source is connected.

Figure 9-16 CPRU Connections

Installing SV9100 Optional Equipment

Table of Contents