Figure 9-61 Digital Station Ports - NEC Univerge SV9100 System Hardware Manual

Hide thumbs Also See for Univerge SV9100:

Table of Contents

Install the 4-Port Digital Logging Unit

Connect the 4-Port Digital Logging Unit device to the USB

cable and plug the USB cable in the PC. Windows responds

with the Found New Hardware wizard.

Insert the provided NEC BackOffice CD in the CD drive of

Direct the installation of the driver to Specific Location and

specify the Driver folder on the CD. Windows should find

and load the device driver.

Before inserting the next USB cable, restart the PC. If

Windows responds with Found New Hardware again, direct

to the CD a second time and restart the PC. After you get a

clean restart and Windows recognizes the device on restart,

install the next device.

Leave the CD in the CD drive and connect the next device,

you may need to direct windows to the CD with each device

you connect. Also, you may need to restart the PC with each

device connection (this may require two restarts per device).

After all devices are connected, restart the PC and view the

devices in Device Manager to ensure proper installation.

Connect the telephone wiring to the 4-Port Digital Logging

Unit. Be sure to note which extension is connected to which

port of the devices (each device has a unique serial

number). In the Recorder window you see the serial number

followed by a trailing digit (1~4), this identifies the port on

Label each Digital Station Port with the extension it

records. Refer to

Before the telephone wiring is connected, the

devices may temporarily show Failed and then

reinitialize. This is normal operation.

Figure 9-36 4-Port Digital Station

Figure 9-61 Digital Station Ports

4-Port Digital Logging Unit

Digital Station Ports

Installing SV9100 Optional Equipment

Table of Contents