Figure 5-49 Removing The Hanger Hook On A Dt Series Terminal; Figure 5-50 Sliding The Hanger Hook Into Position - NEC Univerge SV9100 System Hardware Manual

4.7
5-56
Wall Mounting the Multiline Terminal
You can wall mount a DT series multiline terminal using the base cover or an
optional wall mount unit. A wall mount unit must be used if adapters are installed
on the multiline terminal.
When optional adapters are used, the multiline terminal must be installed on the

wall using the WM-L UNIT (refer to
4.7.1 Wall Mounting a Multiline Terminal using the Base Plate
4.7.1.1 Adjusting the Hanger Hook
1.
2.
3.
5.2.13 WM-L UNIT on page
Remove the hook from the unit.
Figure 5-49 Removing the Hanger Hook on a DT Series
Terminal
Hanger Hook
Turn the hook with the tab toward the top.
Slide the hook until it glides into position forming the hanger
hook for the handset.

Figure 5-50 Sliding the Hanger Hook into Position

Installing DT Series Digital and IP Multiline Terminals
Issue 3.0
5-94).