Table 7-6 Dap Rj-45 Pinouts; Table 7-7 Ap300/Ap400 Led Indications - NEC Univerge SV9100 System Hardware Manual

Issue 3.0
SV9100 System Hardware Manual

Table 7-6 DAP RJ-45 Pinouts

The advantage of Power over Ethernet is that you can provide
the DAPs with power from one location only, e.g., same power
source as the SV9100. On such a location you can install a
UPS (Uninterruptable Power Supply) to increase system
reliability.
3. Connect the other end of the cable to your TCP/IP network.
During the boot process the LEDs will flash on and off. When
LED is solid Yellow it is operational and synchronized to other
DAP or is the synchronization master (refer to
Station LED States and

Table 7-7 AP300/AP400 LED Indications

Flash Pattern
Off
0.5 Seconds On –
0.5 Seconds Off
Short Flash every 2.5
Seconds
Steady On
Continuous Fast Blink Hardware error.
Fast Blink
DAP RJ-45 Socket
Pin No. Connection
1 10/100 Base-T Tx+
2 10/100 Base-T Tx-
3 10/100 Base-T Rx+
4 +48 Volt power
5 +48 Volt power
6 10/100 Base-T Rx–
7 RTN (0 Volt) power
8 RTN (0 Volt) power
Meanings).
Condition Indicated
No Power.
Loading software/firmware.
IP Network error (not connected, no DHCP/
TFTP server, no DAP controller).
DAP Operational and synchronized to other
DAP or is the synchronization master.
DAP operational, but trying to synchronize to
another DAP.
Table 7-8 Base
7-17