7-14
4.
Place the spare battery (if available) in the back section of
the charger; the BATTERY STATUS LED should turn on.
(Pull the battery latch back slightly to fit the battery in the
slot.)
2.2.4.3
Powering on the Handset
To power up the handset, press and hold End until the display
flashes once (about three seconds). The handset searches for
the base station or multi-cell chain it is registered to and
connects to the unit with the strongest signal.
Figure 7-14 ML440 – Insert Handset into Charger
Installing SV9100 Wireless Telephones
Issue 3.0