Figure 9-105 Separate Tilt Leg From Leg Support - NEC Univerge SV9100 System Hardware Manual

Issue 3.0
SV9100 System Hardware Manual
13.3.2 Installing the ADA-L UNIT
Perform the following steps to connect the ADA-L UNIT to the Bottom
Option Interface located underneath the DTL/ITL multiline terminal.
IMPORTANT
WARNING
1. Unplug the line cord from the multiline terminal.
2. Turn the DTL/ITL multiline terminal upside down.
3. Lower the tilt leg to the first position (refer to
Tilt Leg from Leg

Figure 9-105 Separate Tilt Leg from Leg Support

Tilt Leg
4. Push the two stopper tabs through the slots to separate the tilt leg
from the leg support.
5. Lay the tilt leg and the leg support flat to expose ADA-L UNIT
compartment.
6. Carefully pry loose the knockout covering the bottom option interface
(refer to
9-126).
Only ONE ADA-L UNIT can be installed at a time.
To prevent possible damage to the ADA-L UNIT or the DTL/
ITL multiline terminal during installation or removal,
disconnect the line cord/LAN cable and the AC/DC adapter
from the DTL/ITL multiline terminal.
Support).
Figure 9-106 Bottom Option Interface Knockout on page
Figure 9-105 Separate
Stoppers
9-125