Figure 5-74 Removing The Line Key Panel - NEC Univerge SV9100 System Hardware Manual

5-72
5.2.4.1 Installing the 12LK-L KIT
WARNING
1. Turn multiline terminal upside down.

2. Pry the right side panel from the multiline terminal.
3. From the lower left or right corner, pry the Line Key Panel
from the multiline terminal (refer to
the Line Key

Figure 5-74 Removing the Line Key Panel

Installing DT Series Digital and IP Multiline Terminals
To prevent possible damage to the 12LK-L KIT or
the DTL/ITL multiline terminal during
installation or removal, disconnect the line cord/
LAN cable and the
AC/DC adapter from the DTL/ITL multiline
terminal.
Only one 12LK-L KIT can be attached to the DTL/ITL
multiline terminal.
Panel).
Issue 3.0
Figure 5-74 Removing
Line Key
Panel