Figure 9-113 Separate Tilt Leg From Leg Support; Figure 9-114 Bottom Option Interface Knockout - NEC Univerge SV9100 System Hardware Manual

Hide thumbs Also See for Univerge SV9100:

Table of Contents

SV9100 System Hardware Manual

Figure 9-113 Separate Tilt Leg from Leg Support

Push the two stopper tabs through the slots to separate the tilt leg

from the leg support.

Lay the tilt leg and the leg support flat to expose APR-L UNIT

compartment.

Carefully pry loose the knockout covering the bottom option interface

Figure 9-114 Bottom Option Interface

Using the exposed Bottom Option Interface as a guide, install the

APR-L UNIT in the bottom of the DTL multiline terminal. Push down

until left and right tabs are seated (Refer to

UNIT on page

Bottom Option

Figure 9-115 Install APR-L

Table of Contents