Service Terminal Setup; Table 6-3 Site Controller Service Port Pinout; Table 6-4 Rs-232 Port Configuration - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual

Table 6-3 Site Controller Service Port Pinout

RJ45 PIN
1
2
3
4
5
6
7
8

Service Terminal Setup

In the following procedures, whenever there is an instruction to enter software commands, the
commands are presented in bold. Type all the commands exactly as they appear. The command
prompt precedes the command, as in the following example:
Example: SC> help
1.
2.
Table 6-4
Description
Baud Rate
Parity Bit
Data Bits
Stop Bits
6802800U74-N September 2009
Description
FE Rx+
FE Rx-
FE Tx+
RxD
NC
FE Tx-
TxD
GND
Configure the service terminal's RS-232 port with the parameters listed in
Connect an RS-232 cable from the serial port on the service terminal to the RJ45
service port on the front of the Site Controller.
RS-232 Port Configuration
Setting
19200
none
8
1
Service Terminal Setup
Table 6-4.
6-7