Setting Base Radio Ip - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

Setting Base Radio IP

Setting Base Radio IP
To get at read-out of current IP configuration of the Base radios using Boot1:
boot1> spr inet/if/eth0
boot1> spr inet/if/eth1
SUGGESTION
To configure the IP address of the Base Radio in the Test Application, use one of the following commands:
•
•
To change and update IP configuration of the Base radio(s) by using Boot1:
boot1> spw inet/if/eth0 "dhcp:no addr:10.0.253.[XY] mask:255.255.255.0
dev_name:FCCETH dev_unit:1 ethaddr:
where [X = Cabinet number; Y = Position number] and yy:yy:yy:yy:yy:yy is the
MAC or Ethernet address of eth0.
To change and update IP configuration of the Base radio(s) by using Boot1:
boot1> spw inet/if/eth1 "dhcp:no addr:10.0.254.[XY] mask:255.255.255.0
dev_name:FCCETH dev_unit:2 ethaddr:
where [X = Cabinet number; Y = Position number] and yy:yy:yy:yy:yy:yy is the
MAC or Ethernet address of eth1.
6-18
Note down the Ethernet configuration displayed for later use.
cpp -olan1 -i<IP>
cpp -olan2 -i<IP>
It is not allowed to change the original MAC addresses of the Base Radio.
The <IP> in commands above is the new IP address (for example 10.0.253.11)
In the command line above, there is one space between the ethaddr:
and yy:yy:yy:yy:yy:yy.
In the command line above, there is one space between the ethaddr:
and yy:yy:yy:yy:yy:yy.
Chapter 6: Configuration and Testing
yy:yy:yy:yy:yy:yy mtu:1500"
yy:yy:yy:yy:yy:yy mtu:1500"
6802800U74-N September 2009