Synchronizing Non-Volatile Memory (Nvm) Regions - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

Synchronizing Non-Volatile Memory (NVM) Regions

Synchronizing Non-Volatile Memory (NVM) Regions
After introducing major changes in the Non-Volatile Memory (NVM) settings it is recommended to
synchronize NVM regions using the commands described below. Each physical NVM object has two
copies of its contents called the working region and the default region. The working region is used
for normal operation, while the default region is a backup from where the settings are recovered in
case of a memory fault (incorrect checksum) detected in the working region.
In order to synchronize the default region with the working region, use the following
commands at the command prompt:
•
•
•
•
6-30
sfcp -ocontrol -sworking -ddefault
sfcp -oex1 -sworking -ddefault
sfcp -opa1 -sworking -ddefault
sfcp -orxch1 -sworking -ddefault
Chapter 6: Configuration and Testing
6802800U74-N September 2009