Other Site Controller Symptoms; Base Radio / Rfds / Miscellaneous Troubleshooting; Base Radio Troubleshooting; Troubleshooting Overview - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

Hide thumbs Also See for DIMETRA MTS 2:
Table of Contents

Advertisement

Other Site Controller Symptoms

Other Site Controller Symptoms
Table 13-6
Symptom
Initial power up self test fails
Service terminal unable to
communicate with Controller
Controller cannot communicate over
Ethernet
Site Controller functions normally at
first then fails after a period of time

Base Radio / RFDS / Miscellaneous Troubleshooting

The built-in system troubleshooting intelligence is mainly accessed through the Site Controller and
Base Radio Controller(s) LED, Man-Machine Interface (MMI) status and fault indications. This
section describes the Base Radio, RFDS and miscellaneous troubleshooting.

Base Radio Troubleshooting

Troubleshooting Overview

This section serves as a guide to isolate Base Radio failures to the module level. It contains procedures for:
13-20
Other Site Controller Symptoms
Troubleshooting
Verification/Station Operation
Possible Failure
Site Controller
Incorrect cable Incorrect
setup parameters
Cabling problem Site
Controller
Controller overheating
Chapter 13: MTS Troubleshooting
Corrective Action
Replace Site Controller.
Verify cable. Check terminal
configuration.
Check Ethernet cable and 50-Ohm
terminator on Ethernet termination.
Replace Site Controller.
Replace if required.
6802800U74-N September 2009

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dimetra mts 4

Table of Contents