Station Verification Procedures; Base Radio Software Revision Verification - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

Station Verification Procedures
Procedure 6-4 How to Configure pm_config (Continued)
4
5
6
7
Station Verification Procedures
Station Verification Procedures cover methods to verify transmit and receive operations after a Base Radio
module has been installed or replaced. Each section contains the equipment setup and the procedure.
Base Radio Software Revision Verification
Procedure 6-5 How to Verify the Base Radio Software Version Number
Connect one end of the console cable to the service computer.
1
Connect the other end of the console cable to the Service Access port, located on the front
2
panel of the Base Radio (BR).
In normal application mode, login and enter command ver - to display Application Software
3
version, Boot0 version and Boot1 version.
Enter the test application mode:
4
1. Reset the BR. When resetting the Base Radio, press the ESC key when prompted to
interrupt the start up sequence.
2. Type testapp and press Enter.
3. Log on by typing login -ufactory and press Enter. When prompted, enter factory
for password.
Collect revision numbers from the BR by typing: fv -oplatform. Note down the test application
5
software version and then please refer to the System Software Release Note for correct software
version number.
To exit BR Test Application mode, reset the BR, by using the following command from the
6
MMI: reset -oplatform
6-22
To configure the DPM to BR mapping, use the following command:
br <br> dpm <dpm>
To clear the mapping for a given BR, use the following command:
-invalidate <br>
To clear all mapping, use the following command:
-invalidate
To print all mapping, use the following command:
-print
If software version number does not match, perform
Software Upgrade (optional)" on page 6-23
Chapter 6: Configuration and Testing
"Base Radio Test Application
after completion of this procedure.
6802800U74-N September 2009