Configuring Redundant Site Controller - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

Hide thumbs Also See for DIMETRA MTS 2:

Table of Contents

Conﬁguring Redundant Site Controller

Procedure 8-25 Add Additional Site CONTROLLER (Continued)

Conﬁguring Redundant Site Controller

Connect the Ethernet cables previously attached to the Base Radio(s) to the Site Controller. Also

connect the newly added Site Controller to the junction panel according to the scheme below:

Connect RF cable 3066543B10 to GPS connector.

Connect the redundant control signal cable according to the scheme below:

Make sure to follow the color indications on both the cables as well as on the Site

Remove the Terminator from the CAN2 output on the Power Supply Unit and connect the CAN

Bus cable according to the scheme below:

Connect the power cables to the MTS Power Supply Unit.

Redundant Site Controller feature is supported by MTS Software releases:

• MTS SPU R5.2_002.34 or later

• MTS SPU R6.0_001.12 or later

On power up of the Standby Site Controller the Base Radios may dekey and reset. Base

Radios will automatically recover and key up again within 20 seconds.

Junction Panel /

SC1 / RedOut

CAN Bus cable

Chapter 8: Site Controller

SC2 / RedOut

6802800U74-N September 2009

Show Quick Links

Table of Contents

Troubleshooting

Dimetra mts 4