Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual page 402

Hide thumbs Also See for DIMETRA MTS 2:
Table of Contents

Advertisement

Base Radio Alarms
Table 13-7 Generic Base Radio Alarms (Continued)
Alarm ID
ALM_BRC_CP2B_REF_ALM
ALM_DEKEY_FROM_MMI
ALM_GPS_FAILURE
ALM_RESET_PENDING_ALARM
ALM_HW_INIT_FAILED
ALM_RX1_PATH
13-36
Recovery
Description
Action
CP2B reference
Hardware
is not present
automatically
- the alarm
selects another
originates from
reference which
the STIC FPGA
is present.
(which is read
by DSP) and it
is reported as a
fault indication
message from
DSP
BRC is
BRC is de-keyed
de-keyed by
by the software.
using 'dekey'
MMI command
GPS failure
No recovery
action taken by
detected - 1PPS
signal is lost.
the software.
CMP Reset
After the delay
request received
time elapses the
from Site
BRC is reset.
Controller but
delay time for
the reset is set.
Hardware
No recovery
initialization
action taken by
the software.
failure.
RSSI for
No recovery
Receiver path
action taken by
the software.
1 is much
lower than
maximal RSSI
measured for
the remaining
configured
paths.
Chapter 13: MTS Troubleshooting
Clear Action
The alarm will
The alarm may be
be cleared after
reported because of
de-keying BRC.
the external reference
failure or BRC
hardware failure.
The alarm will
be cleared (and
BRC will be
re-keyed again)
after using 'key'
MMI command.
After de-keying
The alarm may be
BRC and
reported because of
regaining the
the 1PPS signal from
1PPS signal the
SC failure or link to
alarm is cleared.
SC failure or BRC
hardware failure.
The alarm will be
cleared only after
resetting BRC.
The alarm will be
The alarm may be
cleared only after
reported because
resetting BRC.
of BRC hardware
configuration error
or BRC hardware
failure.
When the clear
Each time when RSSI
condition is met
for path 1 is less than
then the alarm is
(max_RSSI - mts_re-
cleared.
ceive_path_thresh-
old) then RSSI failure
counter for path 1
is incremented by 1.
Otherwise the counter
is decremented by 2.
After checking the
alarm condition the
counter is set to 0 if it
has a negative value.
The 'rssicnt' com-
6802800U74-N September 2009
Notes

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dimetra mts 4

Table of Contents