Table of Contents
Advertisement
MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual
How to Install
Procedure 15-14 How to Install Redundant XHUB Controller
Wear an ESD strap and connect its cable to a verified good ground. This strap must be worn
1
to prevent ESD damage to any components.
Remove XHUB Controller blind plate if such exist in the upper module cage of the MTS 4
2
Expansion Cabinet.
Label the cables with labels included in the expansion kit.
3
Connect the Ethernet cables to the Base Radio(s) according to the scheme below:
4
Strap the cables.
5
Install the additional XHUB Controller. Use handle to slide the unit into the chassis.
6
Secure the XHUB Controller in the chassis with two M4X10 captive screws.
7
Connect the Ethernet cables to the unit as tagged earlier.
8
Connect the Ethernet cable that derives from the upper Site Controller in the MTS 4 Prime
9
Cabinet (Exp Cab connector).
Reconnect the power cables to the MTS Power Supply Units.
10
Configuration
No configuration is needed.
6802800U74-N September 2009
Part no
3066544B02
3066544B15
3066544B16
3066544B01
Ethernet cables stated above derives from the Base Radio(s) in the MTS 4 Expansion
Cabinet.
At this stage only connect the cables to the Base Radio(s).
Connect the ribbon cables at the rear before sliding the unit in to the chassis.
Cable type
From
Ethernet cable
BR4 / SC2
Ethernet cable
BR1 / SC2
Ethernet cable
BR2 / SC2
Ethernet cable
BR3 / SC2
How to Install
To
XHUB2 / BR4
XHUB2 / BR1
XHUB2 / BR2
XHUB2 / BR3
15-43
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
