Hybrid Combiner In Mts 4; Post Filter - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual
Procedure 7-12 How to Update the Mapping List with the New Unit TrackID (Continued)
4
5
6

Hybrid Combiner in MTS 4

For details about the Hybrid Combiner (HC), see the section

Post Filter

The Post Filter supports non-duplexed configurations. The Post Filter incorporates a DPM. A Post Filter
is only available for the MTS 4 because the MTS 2 does not support non-duplexed configurations.
The bandwidth is 5 MHz on 400 MHz and 19 MHz on 800 MHz.
6802800U74-N September 2009
Delete old CAN Bus unit from the CAN Bus unit mapping list. Use can remove_mapping
<Device>, where <Device> is the old unit name. See example below:
SC> can remove_mapping dpm 2
Add new CAN Bus unit to the CAN Bus unit mapping list.
The new unit Track ID is present on the replaced unit label and indicated as Track
ID not mapped in the list shown in
Use can add_mapping <Device> <TrackID>, where <TrackID> is a TrackID of
the new unit and <Device> is the new unit name: dpm X, where X denotes a digit between 0
and 3). See example below:
SC> can add_mapping dpm 2 JTH0500102
View the updated mapping list using the can check_mapping command and check that
there are no units labelled as Track ID not mapped or Units are not present.
Hybrid Combiner in MTS 4
step 2.
"Hybrid Combiner in MTS 2".
7-25