Figure 8-9 Site Controller - Captive Screws - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

MTS - Replacing Site Controller FRU
Procedure 8-7 MTS - How to Replace Site Controller (Continued)
Loosen the two M4X10 captive screws securing the Site Controller to the chassis.
4

Figure 8-9 Site Controller - Captive Screws

Use handle, and then gently slide the Site Controller from the slot, slot to remove it from the
5
chassis.
Install the replacement Site Controller. Use handle to slide the unit into the chassis.
6
Secure the Site Controller in the chassis with the captive screws.
7
Reconnect all other cabling to the unit as tagged during the removal except the power cables.
8
Reconnect the power cables to the MTS Power Supply Units.
9
Start-up the service terminal.
10
There will be a series of self-tests. By default, after a few seconds, the Site Controller will
11
launch the Site Controller Application. If application software is not installed proceed to
Restoring the Site Controller Software" on page
8-22
Cables are connected at the rear of the Site Controller. Slide out the Site Controller
carefully, tag, and then disconnect the ribbon cables at the rear.
Connect the ribbon cables at the rear before sliding the unit in to the chassis.
8-23.
6802800U74-N September 2009
Chapter 8: Site Controller
"MTS -