Expanding Hybrid Combiner; List Of Equipment In The Expansion Kit; How To Install; Configuration - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

Expanding Hybrid Combiner

Expanding Hybrid Combiner
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
This section describes how to expand Hybrid Combiner for MTS 4.

List of Equipment in the Expansion Kit

When ordering an additional Hybrid Combiner for MTS 4, the following is included in the expansion kit:

Table 15-7 Equipment in Expansion Kit

Kit number
GMLX4339A
GMLX4650A
GMLN4335A
GMKN4407A

How to Install

To install the additional Hybrid Combiner, follow the instructions below.
Procedure 15-11 How to Install Hybrid Combiner for MTS 4
1
2
3
4
5
6
7
8
Configuration
No further configuration is needed when having installed the Hybrid Combiner.
15-38
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
Description
Hybrid Combiner (UHF)
Hybrid Combiner (800 MHz)
Bracket for Combiner
RF Cable
Switch OFF the Power Supply Unit.
Assemble the Bracket with the three M6x10 screws.
Fasten the two M4x10 screws that are to hold the Hybrid Combiner but do not tighten them fully.
Place the Hybrid Combiner on the bracket of the cabinet with the heat sink facing the side
of the cabinet.
Slide the Hybrid Combiner at an angle ensuring that the lip at the back of the Hybrid Combiner
is secured behind the bracket.
Tighten the two M4x10 screws to the bracket.
Attach the TX and antenna cables.
Switch ON the Power Supply Unit
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
Chapter 15: Expansion Options
■ ■ ■ ■
■
■
6802800U74-N September 2009