Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual page 436

How to Install
Procedure 15-1 How to Install Additional Base Radio to MTS 2 (Continued)
9
10
If current MTS 2 configuration include one Duplexer, installation of the Hybrid Combiner
also included in the expansion option is necessary.
15-6
Connect the Power cables, Ethernet cable, Tx cable and Rx Cables to the BR front plate. Make
sure cables are connected according to scheme below:
# Part
number
N/A 3066545B01 DC Power
5
3066543B01 Rx Cable
6
7
N/A 3066543B05 Tx Cable
2 in A) 3066545B02 Ethernet
Index numbers in table above refer to cable connections shown in
in Figure 15-4
DC Power Cable (3066545B01) already exists before expansion of MTS 2.
Switch ON the Power Supply Unit (You do not need to do this if doing a hotswap).
If current MTS 2 configuration includes two Duplexers, installation of the
Hybrid Combiner is not needed.
Cable
type
Cable
for A).
Chapter 15: Expansion Options
La- From
bel
N/A PSU / DC Out
Rx1 Filter pos 1 /
BR2
Rx2 Filter pos 2 /
BR2
Rx3
Filter pos 3 /
BR2
N/A Filter pos 2 /
Tx
N/A SC1 / BR2
6802800U74-N September 2009
To
BR1 / DC IN
BR2 / DC In
SC1 / Power
BR2 / Rx1
BR2 / Rx2
BR2 / Rx3
BR2 / Tx
BR2 / SC1
Figure 15-3 or