Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual page 307

MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual
After all parameters are configured properly and configuration file is loaded to the MTS, Ethernet link
configuration can be inspected by executing .ethconf -STATUS command on the Site Controller MMI.
An example output produced by .ethconf -STATUS command is shown below:
Option
Ethernet Sitelink type
Primary Vlan Tagging
Primary WAN IP Address
Primary WAN IP Mask
Primary WAN Gateway
Primary WAN VLAN ID
Primary IP Tunnel Local Address
Primary IP Tunnel Remote Address
Primary IP Tunnel Fragmentation Size
Primary PVC IP Address
Primary PVC IP Mask
Secondary PVC IP Address
Secondary PVC IP Mask
Green Traffic Color Map
Yellow Traffic Color Map
QOS CIR [kbit]
QOS CBS [bytes]
QOS EIR [kbit]
QOS EBS [bytes]
6802800U74-N September 2009
For description of parameters listed above and instruction on how to configure them
refer to the Tetra EBTS Service Software (TESS) User Guide.
It is recommended to use TESS tool for configuration of Ethernet site link,
especially during upgrade or migration procedures.
Mentioned parameters can be also configured via .ethconf engineering command
on Site Controller MMI. For details, please refer to help that is delivered with
this command by typing .ethconf -?.
MTS - Configuring Ethernet Site Link
Current
Single
on
NOT SET
NOT SET
NOT SET
NOT SET
NOT SET
NOT SET
339
192.168.40.16
255.255.255.0
192.168.41.17
255.255.255.0
7,6,5,4,3,2,1,0
null
512
361
0
0
Next
Single
on
* 10.10.10.1
* 255.255.255.0
NOT SET
NOT SET
* 10.10.10.1
NOT SET
339
192.168.40.16
255.255.255.0
192.168.41.17
255.255.255.0
7,6,5,4,3,2,1,0
null
512
361
0
0
8-31