Toshiba GR200 Series Instruction Manual page 961

How to set the settings for binary output circuits
(vii)
Figure 5.4-6 BO and BIO modules and setting tables related to IO_SLOT2 and IO_SLOT3
Figure 5.4-6 illustrates an example of a binary IO module arrangement and the binary
output circuit printed circuit boards (PCBs). If the user wishes to set the binary output circuits,
the setting targets are on BO1A and BIO1A at locations IO#2 and IO#3. The user should key
the CPL settings from the setting tables for the IO2_SLOT and IO3_SLOT.
The setting table is available for all binary IO modules; thus, the user should understand
and select setting points that are relevant to the BO1A and BIO1A. That is, for the BO1A the
user should choose the setting terms of reference (i.e., binary output circuits #1 to #18) from
BO1A
IO_SLOT2
Setting table (output)
Setting targets: BO1–BO18
b. Setting targets for BO1A (IO#2)
- 940 -
BIO1A
IO_SLOT3
Setting table (in & out)
Setting targets: BO1–BO10
c. Setting targets for BIO1A (IO#3)
GRZ200 (Soft 031 & 032)
6F2S1915 (0.46)