Toshiba GR200 Series Instruction Manual page 808

Input
Command "P1-Control" from the remote
513001 7004016D08 DEV01_CONTROL_REQ
ILK† condition ("P1") passed
Either "SBO mode" or "DIR mode"
(e.g., "ctlmodel" in IEC61850*)
"Automatic sequence control function (AQEQ)§" in progress
ASEQ_MULTI_SEL
Figure 4.9-3 Select P1-control from the remote-end in TPOS01
†Note: The software interlocking (ILK) function provides the operation criteria for "P1
control". The ILK function is discussed separately; note that the operation criteria
is defined by the ILK function itself (i.e., the user cannot set the condition).
‡Note: A "select condition" signal is provided from the select condition scheme. For more
information, see Figure 4.9-20.
§Note: An automatic sequence control (ASEQ) function can provide sequential signals for
automatic control. The TPOS01 operation is blocked for the ASEQ function being
in the operation. For more information of the ASEQ function, see Chapter
and monitoring application: Automatic sequence control function
*Note: The TPOS01 function can run in either the "SBO mode" or the "DIR mode". The
user can use signal called "ctlmodel" when communication is implemented using
IEC61850. To use this signal, the user must map for IEC61850 communication.
Note: To identify the input and output points of the other TPOS logics, see Table 4.9-5,
††
Table 4.9-7, and Table 4.9-10.
Output signal to BO
The TPOS01 function can issue an signal "Select success" at the output point
"TPOS01_P1SL_BO_FLG", when the TPOS01 function determines that the input signal
"Remote-P1-Control" received is true. If the TPOS01 function determines that the "Remote-
P1-Control" is not true, the TPOS01 function returns to the "Wait for a command" stage.
TPOS01 function (Function ID: 513001)
For SBO operation
Select command
with ILK† condition
For DIR operation
Operate command
with ILK† condition
TPOS1-P1
For SBO operation
Select command
without ILK† condition
For DIR operation
Operate command
without ILK† condition
In SBO operation
In DIR operate
Select condition‡
- 787 -
Selection logic in TPOS01
1≥
&
&
&
&
6F2S1915 (0.46)
Output
&
To "Wait for a next
command"
To BO connection
"TPOS01_P1SL_BO_FLG"
(513001 8A04011DC4)
0
t
Select "success"
0.1s
To "Wait for a command"
t
0
Select "Failed"
0.6s
††
Control
.
GRZ200 (Soft 031 & 032)