Toshiba GR200 Series Instruction Manual page 809

Receiving "select command P2-control" from the remote-end
(ii)
Figure 4.9-4 outlines the reception of the select command 'P2-control' from the remote-end.
Wait for a command
Select stage
P1 control from the remote-end
P2 control from the remote-end
Signal reception
IEC61850
P3 control from the remote-end
P1 control from the local-end
P2 control from the local-end
P3 control from the local-end
P1 control by the PLC function
P2 control by the PLC function
P3 control by the PLC function
Figure 4.9-4 Outline of select command 'P2-control'
Input point mapped from the communication
Figure 4.9-5 shows the select logic when a "Select command P2 (Remote-P2-Control)" signal is
received at the input-point "DEV01_CONTROL_REQ".
Input
Command "P2-Control" from the remote
513001 7004016D08
DEV01_CONTROL_REQ
ILK† condition ("P2") passed
Either "SBO mode" or "DIR mode"
(e.g., "ctlmodel" in IEC61850*)
"Automatic sequence control function (AQEQ)§" in progress
ASEQ_MULTI_SEL
Figure 4.9-5 Select P2-control from the remote-end in TPOS01
†Note: The ILK function provides the operation criteria for "P2-control".
Note: To identify the input and output points of the other TPOS logics, see Table
††
Selection logic
TPOS01 function (Function ID: 513001)
For SBO operation
Select command
with ILK† condition
For DIR operation
Operate command
with ILK† condition
TPOS1-P2
For SBO operation
Select command
without ILK† condition
For DIR operation
Operate command
without ILK† condition
In SBO operate
In DIR operate
Select condition‡
- 788 -
Failed
Select
Signal output
decision
Success
Selection logic in TPOS01
1≥
&
&
&
&
6F2S1915 (0.46)
Wait for a command
Cancel logic
Cancel command
Cancel logic
Operate logic
Operate command
Operate logic
Output
&
To BO connection
"TPOS01_P2SL_BO_FLG"
(513001 8A04011DC6)
0
t
Select "success"
0.1s
To "Wait for a command"
t
0
Select "Failed"
0.6s
††
GRZ200 (Soft 031 & 032)