Toshiba GR200 Series Instruction Manual page 481

Hide thumbs Also See for GR200 Series:

monitoring application: Control hierarchy

in Table 3.6-3.

Settings in LED logics

The user can program the status and the signal of the LED, so that the LEDs are possible to

switch off upon occurrence of the reset. As shown in the logic relating to the LED†, each logic

has a timer and a setting; accordingly, setting Latch should be set for the operation of the

LEDR function. Additionally, the user should connect the signal LED_RST_CMD with the LED

†Note: For more information on LED logics, see Chapter

machine interface: LED indicators

Settings using GR-TIEMS

Figure 3.6-9 shows how to connect the reset signal LED_RST_CMD for the LED-03 logic. The

user can assign a reset signal for the respective LED logics by the drag and drop operation.

The user should also select Latch for the behavior from the pull-down menu.

Set [Behavior] to Latch

Figure 3.6-9 Settings for LED-03 circuit provided by "Setting I/O menu" of GR-TIEMS

Settings using IED screen

The operation from the IED screen can also be set. See Chapter

. "LEDR01_CTRL_RIGHT" is provided

6F2S1915 (0.46)

Technical description: Human

Choose the signal

LED_RST_CMD for the

LED-03 logic

User interface: I/O setting sub-

GRZ200 (Soft 031 & 032)