Figure - Toshiba GR200 Series Instruction Manual

operate instantly. As shown in Figure 2.1-53, the reach of the zone1
majority of the line length AB, whereas the zone1
beyond the busbar B. Given the existence of the measuring errors in the VT and the CT,
approximate 80 to 90% of the line AB is required to set for the reach setting at the zone1
When the ZS/ZG function is used in the main relay, zero should be set for the both settings
[TZ*S] in order that tripping is executed instantly.
Setting for adjacent lines (Zone2 serviced as a backup relay)
(ii)
The reach setting in the zone2
adjacent line BC. To preserve the operation selectivity for the adjacent line BC (i.e., the
operation in the zone1
the zone1 .
(Y)
Note that setting TZ2
tripping in the zone1
(X)
taken into account. Note that setting TZ2
(2.1-40):
where we have defined
T p : Maximum operating time in the main (primary) relay
(Y)
T cb : Opening time in the circuit breaker
(Y)
T2 : Minimum operating time for the zone2
(X)
T Zone2 : Reset time for the zone2
(X)
Figure 2.1-54 shows that the adjacent line BC is too short so that the coordination
between the zone1 and the zone2
(Y)
required to be larger than setting TZ2(Y); consequently, the coordination between is achieved.
is required to cover 100% of the line AB plus about 20% of the
(X)
), the user should set the reach of the zone2
(Y)
does not influence the CTI regarding the zone1
(X)
is preferred, the CTI between the zone2
(X)
(��) (��)
(��)
����2 > �� + ��
�� ����
(��)
����2 > ����1
(X)
is not realized straightforward. Hence, setting TZ2(X) is
(X)
- 82 -
should be independent on faults that occur
(X)
(X)
should be satisfied with Equations (2.1-39) and
(��)
(��)
+ �� − ��2
��������2
(��)
,
(Y)
,
(X)
6F2S1915 (0.46)
is required to cover the
(X)
not beyond the reach of
(X)
. If delayed
(Y)
and the zone1 should be
(Y)
(2.1-39)
(2.1-40)
,
(Y)
GRZ200 (Soft 031 & 032)
.
(X)