Fujitsu AIRSTAGE J-II Design & Technical Manual page 418

Important: Network Convertor will not operate if,
● VRF network system address (Outdoor and Indoor units address) allocation
information are not registered to Network Convertor.
● XIF data information and VRF network system address allocation information must
not be same.
● Binding and Commissioning is not executed. (During binding, read out the Network
Convertor Neuron ID by pushing BMS service switch [SW 2] on the main PC board
of Network Convertor.)
● If the ID number registered to the Network Convertor is not same as the ID number
which is included in the XIF of Network Convertor.
- (05 - 114) -