Fujitsu AIRSTAGE J-II Design & Technical Manual page 653

2-12. TOUCH PANEL CONTROLLER
ADDRESS SETTING
„ „
Display the Installer Setting screen and press "Change" button of "1. The controller
●
„
Address Number Setting".
If it changes to "1. The controller Address Number Setting" screen, press "01" button of
●
„
Address No., and then press "OK" button.
Ex) When setting the Address Number to "01".
If it returns to Installer Setting screen, make sure that Address No. is "01", and then end.
●
„
Note:
Address No. can be set between "00" and "15". (Up to maximum 16 Touch Panel
●
Controller can be installed to 1 system).
● When installing two or more Touch Panel Controller, set up so that Address No. does
not overlap.
● Please refer to the OPERATING MANUAL of Touch Panel Controller for details.
● Please keep Address No. of Touch Panel Controller from overlapping the controller
(Central Remote Controller, Network Convertor for LonWorks, and Network Convertor
for Group Remote Controller) connected to the same VRF Network system
01
- (07-127) -