PREPARATION
3) Turn on the power to the indoor unit.
●
By turning on the power indoor units initializes EEV, so make sure the piping air-tight test and
vacuuming have been conducted before turning on the power.
●
Also check again to make sure no wiring mistakes were made before turning on the power.
Breaker ON
SWITCHING SELECTION OF ADDRESS SETTING MODE
4) To activate the address setting mode, hold down the three buttons of "MENU", "<" and
"ENTER" at the same time for 2 seconds or longer.
5) Select the "13" in Menu 2 Settings. Then press the "ENTER" button.
Indoor
units
Address setting mode initial display
- (07-41) -
Indoor
units