Fujitsu AIRSTAGE J-II Design & Technical Manual page 626

COMPLETION OF FUNCTION SETTING MODE
„ „
(13) Press and hold the "MANUAL/AUTO
button for 3 seconds.
MANUAL AUTO
IR RECEIVER UNIT
Each LED light brightness is darkening though the content
¾
of the display doesn't change.
The function setting signal is not received after switched function setting completion mode. (Pi Pi Pi Pi Pi)
¾ „
Press the "MANUAL/AUTO
¾ „
mode.
RECONFIRMATION OF FUNCTION SETTING
„ „
(15) Press and hold the "FAN" and the " SET
TEMP. " buttons. Whilst holding these 2
p
buttons, press the "RESET" button.
FAN
¾
SET TEMP. ( )
RESET
(16) Function number to be confirmed is displayed.
Refer to (7).
Press the "TIMER set (-)" button.
"TIMER set (-)"
Case1 : When setting number is one digit.
(Example) Function number : 30, Setting number : 01
0.5sec ON / 0.5sec OFF
OPERATION LAMP
(GREEN)
3 times
TIMER LAMP
(ORANGE)
0.5sec ON / 0.5sec OFF
FILTER LAMP
1 time
(RED)
(Phase1) : 12sec
"
Pi Pi Pi
MANUAL
AUTO
" button again for 3 sec to return to if required to return the function setting
Function setting
mode display
Case2 : When setting number is two digits.
...
3 times
OFF
...
1 time
(Phase1) : 12sec
- (07-100) -
(14) Press the "RESET" button.
After pressing the RESET
button, please set the custom
code again if b,c,d setting.
RESET
(Example) Function number : 26, Setting number : 31
0.5sec ON / 0.5sec OFF
OPERATION LAMP
2 times
(GREEN)
0.5sec ON / 0.5sec OFF
TIMER LAMP
(ORANGE)
0.5sec ON / 0.5sec OFF 0.5sec ON / 0.5sec OFF
FILTER LAMP
1 time
(RED)
(Phase1) : 12sec
...
OFF
6 times
...
OFF
...
3 times
(Phase2) : 12sec