Fujitsu AIRSTAGE J-II Design & Technical Manual page 650

DIP SWITCH 1 SETTING
„ „
SW1 setting prohibited
z „
SW1
OFF
u
ON
SW2 setting
z „
● Dual remote controller setting
Set the remote controller SW2 according to the following table.
Number
of remote
controller
1 (Normal)
u
2 (Dual)
SW3 setting prohibited
z „
SW3
OFF
u
ON
SW4 setting prohibited
z „
SW4
OFF
u
ON
SW5 setting prohibited
z „
SW5
OFF
u
ON
SW6 setting
z „
Memory backup setting (Wired remote controller only)
●
Set to ON to use batteries for the memory backup.
If batteries are not used, all of settings stored in memory will be delete if there is a power
failure.
SW6
OFF
u
ON
Never turn it ON in the case of simple remote controller.
(u...Factory setting)
Fixed at OFF
Setting prohibited
(u...Factory setting)
Master unit Slave unit
SW2 SW2
OFF -
OFF ON
(u...Factory setting)
Fixed at OFF
Setting prohibited
(u...Factory setting)
Fixed at OFF
Setting prohibited
(u...Factory setting)
Fixed at OFF
Setting prohibited
(u...Factory setting)
Memory backup
Invalidity
Validity
- (07-124) -
Indoor unit
1 2 3
When ground wire
is necessary
1 2 3
Master unit
Remote controller
Remote controller cable
1 2 3
Slave unit