Table of Contents
Advertisement
Philips Semiconductors
ARM-based Microcontroller
Compare <address1> <address2> <number of bytes>
Table 212: ISP Compare command description
Command
Input
Return Code
Description
Example
Flash Memory System and Programming
M
Address1(DST): Starting Flash or RAM address from where data bytes are to be compared. This
address should be on word boundary.
Address2(SRC): Starting Flash or RAM address from where data bytes are to be compared. This
address should be on word boundary.
Number of Bytes: Number of bytes to be compared. Count should be in multiple of 4.
CMD_SUCCESS | (Source and destination data is same)
COMPARE_ERROR | (Followed by the offset of first mismatch)
COUNT_ERROR (Byte count is not multiple of 4) |
ADDR_ERROR |
ADDR_NOT_MAPPED |
PARAM_ERROR
This command is used to compare the memory contents at two locations.
"M 8192 1073741824 4<CR><LF>" compares 4 bytes from the RAM address 0x4000 0000 to the 4
bytes from the flash address 0x2000. Compare result may not be correct when source or
destination address contains any of the first 64 bytes starting from address zero. First 64
bytes are re-mapped to flash boot sector.
LPC2119/2129/2194/2292/2294
277
Preliminary User Manual
May 03, 2004
Advertisement
Table of Contents
