Resuming Bitlocker Functionality - Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual

In order to prevent communication problems, it is necessary to update the
changed MAC address stored in the related ifcfg-eth<x> definition file.
Procedures may differ depending on your Linux/VMware OS or the
definition file on the client system. Use the following information as
reference. Ask the system administrator to change the definition file.
To update the MAC address, proceed as follows:
▶ After replacing a network controller or the system board, switch on and boot
the server, see
The hardware configuration tool for Red Hat Linux, will launch at boot and
detect the new and/or changed hardware on your system.
▶ For the changes to take effect, you need to reboot the network by entering
the following command:
# service network restart
If the system board or network controller offers multiple LAN ports, it
is necessary to update the remaining ifcfg-eth<x> definition files
accordingly.
▶ Update the NIC configuration file to reflect the new card sequence and MAC
address.
5.3.12

Resuming BitLocker functionality

If BitLocker Drive Encryption has been suspended for maintenance purposes
(see "Suspending BitLocker functionality" on page
to complete the service task.
RX2540 M7
"Switching on the server" on page
Upgrade and Maintenance Manual
Basic software procedures
71.
89), it has to be reenabled
107